Sony BRC-Z330 - Manual (Page 57)

A
ppe
ndix
List of Messages
57
Appendix
List of Messages
The following messages may appear on the screen. Take
the necessary measures shown below.
Indicators on the BRC-Z330 camera
Messages for the BRC-Z330 camera
Indicator Meaning/remedies
STANDBY lamp
flashes. The camera stopped moving due to an
error in the pan/tilt mechanism. Reset
the pan/tilt position or turn off the power
of the camera and turn it on again.
The tally lamp
flashes. Turn off the power of the camera, and
consult with your Sony dealer.
Message Meaning/remedies
Please restart system You are prompted to restart the power of
the camera after you changed the setting
of “IMG-FLIP” in the SYSTEM menu.
Use the POWER switch on the supplied
Remote Commander or the POWER
button on the RM-BR300 Remote
Control Unit to turn the power off, then
on. The changed setting becomes
effective.
PRESET xx OK
(xx = preset position
numbers 01 to 16) When you store the camera settings into
the memory (POSITION 1-16), the
message will appear for 2 seconds.
One Push WB...OK
(NG) While the white balance is automatically
adjusted, the message will appear. Wait
for a while. When the adjustment is
complete, it will disappear.
STOP
(The message will
flash in FAN
MOTOR on PAGE6
in the STATUS
menu.)
Turn off the power of the camera, and
consult with your Sony dealer.
CAUTION
COOLING FAN
STOPPED! Turn off the power of the camera, and
consult with your Sony dealer.
*[ENTER]: EXIT This message appears while you adjust H
PHASE in the SYSTEM menu. To exit
from the adjustment, press the HOME
button on the Remote Commander or the
button on the top of the joystick on the
Remote Control Unit.
*PUSH ENTER
BUTTON This message appears when you move
the cursor to H PHASE in the SYSTEM
menu. To start the H PHASE adjustment,
press the HOME button on the Remote
Commander or the button on the top of
the joystick on the Remote Control Unit.
PRESET (xx) OUT
OF RANGE (xx =
preset position
numbers 01 to 16) This message appears when you preset
the camera position when the pan/tilt
position of the camera is out of range of
the current PAN-TILT LIMIT setting.
This camera position presetting will fail
to be performed. Perform the presetting
again after moving the camera within the
range of the PAN-TILT LIMIT setting.
Message Meaning/remedies