4 advanced chart setup – Standard Horizon CP1000C User Manual
Page 56
Page 58
GPS chartplotters
Landmarks
On
On
Off
Off
Cultural Features
On
Off
Off
Off
Lat/Lon Grid
On
Off
On
Off
Chart Boundaries
On
Auto
Off
Off
Cartography
On
On
Off
On
Mixing Levels
On
Off
On
Off
Objects Overlap
Off
On
Off
On
1. To change to one of the pre-programmed settings, press [MENU] and move the
Shuttlepoint knob to highlight SETUP and press [ENTER].
2. Move the ShuttlePoint knob to CHART SETUP and press [ENTER].
3. Move the Shuttlepoint knob to PRESETS and press [ENTER].
4. Move the ShuttlePoint knob up or down to select the desired preset and press [ENTER].
5. Press [CLEAR] or move the ShuttlePoint knob to the right until the Chart Page is shown.
10.0.4 Advanced Chart SetUp
The GPS Chart plotter also allows you to customize all the chart settings. The next sections
will describe all the selections that can be customized.
Figure 10.0.4 - Advanced Chart SetUp
10.0.4.0 Marine Settings Menu
The Marine setting menu controls the details shown from an optional C-MAP NT or NT
+
C-CARD. Selections included US or International Nav-Aids, Tide and Currents, and Light
Sectors can be enabled to disabled from this menu.
Names
: Enables or disables the display of names of areas on the land and water. The default setting is on.
Nav-Aids
: Lights, Signals, Buoys and Beacons are displayed differently on maps around the world. This
selection allows the Nav-Aid to be displayed to your preference. Selections are
US
: Draws Nav-Aids using NOAA Symbols. Default setting.
US simple : Shows complex objects as one icon only. This selection may be preferred if the
screen becomes cluttered.
INT
: Draws Nav-Aids using International Symbols
INT Simple : Shows complex objects as one icon only. This selection may be preferred if the
screen becomes cluttered.
Off
: Turns off all Nav-Aids.
Light Sectors
: Enables or disables the light sectors shown on the display.
Attention Areas
: Enables or disables the display of Attention areas( areas which special attention by the mariner
is required, due to some natural or manmade hazards or sailing regulations and restrictions.)
Tides & Currents : Enables or disables the display of Tides and Currents.
NOTE
When Tide and Current display is disabled the Tide Station search cannot be activated.