Standard Horizon CP1000C - Manual (Page 72)

Page 74 GPS chartplotters
Backlight
The second option allows to set the backlight. Operates in similar mode as Contrast.
13.0.2 Cartridges
To check the C-CARD and its connector.
Background ROM
To test the WorldWideBackground. If there is not a malfunction, the code of the Background
and the message "OK" are shown, but if the Background is defective the message "Faulty"
is shown.
C-CARD Test
To test the C-CARD. There are the possible situations:
1. if there is a C-CARD inserted in the slot and there is not a malfunction, the name of the
C-CARD zone and the message "OK" are shown.
2. if there is a C-CARD inserted in the slot, but it is a defective C-CARD, the name of the
C-CARD zone and the message "Faulty" are shown.
3. if there is not any C-CARD inserted in the slot, the message "not present" is shown.
4. if there is a User C-CARD inserted in the slot, the message USER C-CARD is shown.
C-CARD Connector
Indicates if there is a malfunction in the connector.
13.0.3 Serial Ports
If you are having problems receiving data from the position-finding instrument, this test
should help determine the problem.
Change Parameters
To change the parameters of the serial interface. This menu allows to select the Port (Signal
Source) between PORT 1 or PORT 2, the Baud Rate between 300, 1200, 2400, 4800 or
9600, the Data Bits (Word Length) between 7 or 8, the Parity between even, odd or none,
the Stop Bits between 1 or 2. Default settings are: Port = PORT 1, Baud Rate = 4800, Data
Bits = 8, Parity = none, Stop Bits = 1.
Input Data Display
To allow the chartplotter to act as a computer terminal and display the incoming data exactly
as it is received.
If the data displayed on the screen is unrecognizable, you may have selected the wrong
input parameters for your particular receiver, for example, Baud Rate 9600 instead of Baud
Rate 4800. Check your receiver manual to be sure that you have selected the proper
parameter. If the screen is blank, you may have a broken connection, and no data is being
received or you may have connected the device to the other input port.
Use [ZOOM IN] to stop (or continue after pause) data displaying, [ENTER] to show data
in hex or ASCII mode (normal or small) and [CLEAR] to exit.
13.0.4 Modem test
Checks the Modem connections (to be used only if the C-COM Modem is connected).
Press [ENTER] to select the desired Modem Port to the Port to which the Modem C-COM
is connected.