Sony VPH-D50HTM - Manual (Page 13)

13
(GB)
Selecting the input signal or video memory number
can be done easily.
1 11111/u u u u u (on/standby) keys
Press the 1 key to turn on the power and the u key to
standby when the MAIN POWER switch on the
projector is set to ON.
2 INPUT SELECT keys
Select the input signal.
VIDEO: The video or S video signal input from the
VIDEO IN or S VIDEO IN (or Y/C IN) connectors
SEL (select): Select the signal input from the VIDEO
IN or S VIDEO IN (or Y/C IN) connectors by
pressing this key after pressing the VIDEO key.
A: The RGB, component or HDTV signal input from
the INPUT A connectors
B: The RGB, component, HDTV, S video or video
signal input from the INPUT B connectors
C: This key does not function with this projector.
3 VIDEO MEMORY keys
Select the preset or adjusted data by pressing keys 1 to
10. To reset to the data of the input signal, press OFF
key.
4 Lithium battery holder
Install the supplied lithium battery.
u
A B C
1 2 3
4 5 6
7 8 9
1 0
1
VIDEO
SEL
OFF
1
2
3
4
VIDEO MEMORY
INPUT
SELECT
Lithium battery installation –– RM-PJD50
1
Pull out the lithium battery holder from the remote
control.
2
Install the lithium battery.
3
Put the lithium battery holder back into the remote
control.
Notes on the lithium battery
• Keep the lithium battery out of the reach of children.
• Should the battery be swallowed, immediately
consult a doctor.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer’s instructions.
+ side facing upward
Remote Control RM-PJD50