Sony VPH-D50HTM - Manual (Page 19)

19
(GB)
To Press
Trun off the on-screen display the STATUS OFF key. The menus and warning
messages appear even if the OFF key is pressed.
To restore the on-screen display, press the
STATUS ON key.
Cut off the picture the MUTING PIC key.
To restore the picture, press the MUTING PIC
key.
1
Press the MAIN POWER switch on the front of the projector.
The u STANDBY indicator on the control panel lights in orange and
the projector goes into the standby mode.
2
Press the ON (1) key on the remote control or the POWER ON key of
the control panel.
The POWER ON indicator lights in green.
A white screen with the message shown below (warming up screen)
appears on the screen. Make sure to allow the projector to warm up for
20 minutes after turning it on.
The message disappears temporarily in about 35 seconds, and will
appear subsequently for 5 seconds every 30 seconds.
Press the MENU key to cancel the warming up screen and see the
picture immediately after the projector is turned on if, for example, the
adjustment has been finished and warming up is not needed.
3
Turn on the power of the connected equipment.
4
Select the input signal to be projected by pressing the INPUT SELECT
key.
VIDEO and SELECT (SEL) keys: To project the signal input from
the equipment connected to the VIDEO IN or S VIDEO IN (or Y/C
IN) connectors. Select VIDEO or S VIDEO by pressing the VIDEO
key, then the SELECT (SEL) key.
A: To project the RGB, component or the HDTV signal input from the
equipment connected to the INPUT A connectors.
B: To project the RGB, component, HDTV, S video or video signal
input from the equipment connected to the INPUT B connectors.
Note
When you select the input signal connected to the INPUT A or INPUT B section,
be sure to select the correct signal in the SET SETTING menu. If an incorrect
signal is selected, picture may be distorted.
For details, see “The SET SETTING Menu” on page 34 (GB).
5
Adjust the picture.
For details, see “Adjusting the Picture” on page 20 (GB).
6
To turn the power off, press the STANDBY (u) key on the remote
control or the POWER OFF key on the control panel of the projector,
then set the MAIN POWER switch on the projector to OFF.
I N P U T - A
F o r o p t i m u m
p e r f o r m a n c e
w h i t e s c r e e n w i l l
r e m a i n f o r 2 0 m i n .
F o r i m m e d i a t e u s e ,
p u s h [ M E N U ] k e y .