Siemens MC60 - Manual (Page 11)

©
Sieme
ns
AG
2003, L:\MC6
0_Maguro\en\fug\_
von_
itl\M
C60_fug_EN_03
1009\MC
60_fug_EN
_0310
09_FM\MC60
_Startup.fm
left page (10) of MC60 Maguro en, A31008-H5760-A1-1-7619 (21.10.2003, 14:54)
Getting started 10
VAR Langua
ge: English; VA
R issue
da
te
: 1
6-Juli-
2003
Charge battery
The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone, plug
power supply unit into a mains pow-
er socket and charge for at least two
hours .
Display when charging is in progress
h
During charging.
Charging time
An empty battery is fully charged
after about 2 hours. Charging is only
possible within a temperature range
of +5 °C to +40 °C. If the tempera-
ture rises/falls 5 °C above/below this,
the charge symbol flashes a warn-
ing. The mains voltage specified on
the power supply unit must not be
exceeded (Operating time, p. 98).
Charge icon not visible
If the battery has been discharged
fully the charge icon is not immedi-
ately visible when the power supply
unit is plugged in. It will appear after
up to two hours. In this case the bat-
tery is fully charged after 3-4 hours.
Only use the power supply unit provided!
Display while in service
Charge level display during opera-
tion (empty-full):
a d g
A beep sounds when the battery is
nearly empty. The charge level of the
battery is only displayed correctly
after an uninterrupted charging/dis-
charging cycle. You should therefore
not remove the battery unnecessarily
and where possible not terminate the
charging process early .
Additional information
The power supply unit heats up when used
for long periods. This is normal and not
dangerous.
If the battery is removed for longer than
30 seconds, the clock must be reset.