Sony PCS-1/1P - Manual (Page 116)

116
Using the Communication Transducer (CTE)
Using the Communication Transducer
(CTE)
The CTE Communication Transducer is an integrated system equipped with
uni-directional microphones and omni-directional acoustic speaker. The unit is
enabled to pick up clear voice with minimum background noise from all
directions and to emit clear sound equally in all directions.
To connect the CTE-600 Communication Transducer
To use the Communication Transducer (CTE)
• Set “CTE” in the Audio Setup menu to “AUX”. (page 46)
• Set the SYSTEM SELECT switch at the bottom of the Communication
Tranceducer to “PCS”.
For detailed information on the Communication Transducer, refer to the
Operating Instructions that come with the Communication Transducer.
DC 19.5V
AUDIO OUT AUDIO IN AUX1– VIDEO IN–AUX2 CAMERA UNIT MIC
(PLUG IN POWER)
(MIXED)
AUX MAIN– MONITOR– SUB
VIDEO OUT
RGB OUT
IR OUT
100BASE-TX 10BASE-T
1 2
1 2 ISDN UNIT WHITE
BOARD
DSB
TERMINAL VISCA OUT
to an input/output
connector
AC adaptor (supplied
with the CTE-600 )
CTE-600
to DC 6V
to a wall
outlet
to LINE
IN
Connecting
cable
(supplied
with the
CTE-600)
Connecting cable
(not supplied)
Connecting cable
(not supplied)
to AUDIO
IN
to AUDIO OUT
to an input/output
connector
to LINE
OUT
Interface box
(supplied with the CTE-600)