Sony PCS-1/1P - Manual (Page 131)

131
Connection Example Using the Data Solution Box
C
h
a
p
te
r 5:
D
a
ta
C
onf
e
ren
ce
To use the Communication Transducer connected to the Data Solution Box
• Set “CTE” in the Audio Setup menu to “DSB AUX IN” (page 46).
• Set the SYSTEM SELECT switch at the bottom of the Communication
Transducer to “PCS”.
You cannot use two or more Communication Transducers in a room and cannot use it
with other microphones together.
For detailed information on the Communication Transducer, refer to the
Operating Instructions that come with the Communication Transducer.
To connect the CTE-600 Communication Transducer
Note
AUX MIC 1 MIC 2 MIC 3 MIC 4 MIC 5 TO PROCESSOR RGB OUT OUT LINE OUT IN
to a wall
outlet
to AUX IN
to an input/output connector
to an input/output
connector
Connecting cable
(supplied with the
CTE-600)
to LINE
OUT
Connecting cable
(not supplied)
PCS-DSB1 Data Solution Box (Rear)
CTE-600
AC adaptor
(supplied with
the CTE-600)
Interface box
(supplied with the CTE-600)
to DC 6V
to AUX OUT
to LINE
IN