Sony PCS-1/1P - Manual (Page 137)

137
Displaying the Picture on a Projector or Monitor
C
h
a
p
te
r 5:
D
a
ta
C
onf
e
ren
ce
RGB OUT (DSB): Outputs the signal to a monitor (Monitor D in the
illustration above) connected to the RGB OUT connector on the Data
Solution Box.
When “Dual Monitor” is set to “Off” in the General Setup menu, output to a monitor
connected to the VIDEO OUT MONITOR SUB connector is not available.
When connecting the monitor to the RGB OUT connector on the
Data Solution Box
The menus may not be displayed. In this case, change the setup of your system
as described below.
1 Connect your monitor to the RGB OUT connector on the Communication
Terminal.
2 Set “Dual Monitor” to “Off” and “Monitor Out” to “RGB OUT (DSB)” in
the General Setup menu.
3 Change the connection of the monitor to the RGB OUT connector on the
Data Solution Box.
This setting is available when “Dual Monitor” is set to “On” in the General
Setup menu.
The first monitor for displaying motion pictures is fixed to the monitor
connected to the VIDEO OUT MONITOR MAIN connector on the
Communication Terminal (Monitor A in the illustration).
Select the output to the second monitor using the “Sub Monitor Out” setting in
the General Setup menu.
VIDEO OUT: Outputs the signal to a monitor connected to the VIDEO OUT
MONITOR SUB connector (Monitor B) on the Communication Terminal.
RGB OUT: Outputs the signal to a monitor (Monitor C) connected to the RGB
OUT connector on the Communication Terminal.
RGB OUT (DSB): Outputs the signal to a monitor (Monitor D) connected to
the RGB OUT connector on the Data Solution Box.
Note
Outputting the Signal to Two Monitors