Sony UP-CR20L - Manual (Page 14)

14
Controls and Functions
Chap
te
r 2
Pr
epa
ra
tio
n
s
g Output cover
Attach this to the output tray to prevent printouts from
ejecting too far out of the output slot when printing.
h Output slot
Printouts are ejected from here.
i Ribbon door (page 21)
Open and close this when replacing the ink ribbon.
This does not open when the unit is turned on. For details,
see “Loading the Paper Roll and Ink Ribbon” on page 17.
j Paper door (page 19)
Open and close this when replacing paper rolls.
This does not open while printing is in progress.
k Paper door lever
Use this to open the paper door.
When the paper and ribbon doors are open
A Paper core
Insert this into the paper roll.
B Ribbon tray
Place the ink ribbon here.
C Paper adapter (blue)
D Paper adapter (pink)
Attach the paper adapters to the printer when using the
2UPC-R203/R205 series printing pack.
l Scrap receptacle (page 22)
Margins of empty space are crated between each printout.
These margins are cut off during printing and dropped into
this receptacle.
Rear
a Filter cover
The ventilation filter is located under here.
b Display stand
Use this stand to adjust the angle of the display.
c Extension connector cover
The connectors that are required when using extension
functions are located under here.
When the extension connector cover is open
A RS-232C connecter
Allows connection of a commercially available
thermal sheet printer or similar device.
B USB port (device) (page 48)
Use a commercially available USB cable to connect
the unit to an SX-WSG1, computer, or similar
device.
1)
1) Operation is not guaranteed when connected by a USB hub.