Sony UP-CR20L - Manual (Page 20)

20
Loading the Paper Roll and Ink Ribbon
Chap
te
r 2
Pr
epa
ra
tio
n
s
Paper with 127-mm (5-inch) width: 2UPC-R203/
R205 series Printing Pack
Attach the blue paper adapter to the left side of the unit,
and the pink paper adapter to the right side. (The unit is
factory shipped with the paper adapters attached.)
Press the portions indicated by the arrows until the tabs at
the top lock into place.
Paper with 152-mm (6-inch) width: 2UPC-R204/
C26/R206 series Printing Pack
Remove the blue and pink paper adapters.
Store removed paper adapters in a safe place.
5
Load the paper roll.
Be sure to load the paper roll with the arrow on the seal
pointing inside the unit.
• To prevent the paper roll from sliding off, hold both
sides of the paper core when loading it into the unit.
• Do not touch the print surface (inner surface of the
paper) after the paper is loaded. Fingerprints, sweat,
and creases in the paper may affect print quality.
• Be sure to insert the paper roll fully into the unit.
6
Remove the seal affixed to the paper roll.
Be sure to remove the seal completely. In addition,
remove the seal slowly to avoid leaving parts of the
adhesive on the paper. If any part of the seal is left
inside the printer, malfunctions may occur.
Note
blue pink
Notes
Note