Samsung ML-1200 - Manual (Page 25)

P RINT M EDIA P RINT M EDIA 4.12
Printing on Preprinted Paper
1
Load letterhead into the input tray
with the design face up, bottom
edge toward the printer.
Adjust the guide to fit the width of the
paper stack.
2
To print on preprinted paper, configure
the paper source, type and size in the
software application. For details, see
page
5.3 .
Guidelines
• Letterhead must be printed with heat-resistant ink that will not melt, vaporize, or release
hazardous emissions when subjected to the printer’s fusing temperature of 400°F
(205°C) for 0.1 second.
• Ink on letterhead must be non-flammable and should not adversely affect any printer
rollers.
• Forms and letterhead should be sealed in moisture-proof wrapping to prevent changes
during storage.
• Before loading preprinted paper as forms and letterhead, verify that the ink on the paper
is dry. During the fusing process, wet ink can come off preprinted paper.
Printing on Card Stocks
2 Push the output lever down.
1
Load print media in the input tray with
print side up, short edge first .
Adjust the guide to fit the width of the
media.
3 Configure the paper source, type in the
printer driver’s properties (see page
5.3 ) and print.
Postcards, 3” X 5” index cards can be printed with the Samsung ML-1200 Series printer.
Guidelines
• Insert the short-edge first into the input tray . To print in landscape mode, make this
selection through the software. Inserting paper long-edge first may cause a paper jam.
• Do not print on card stock that is too small or too large. The minimum size is 76 X 127
mm (3” X 5”) for the manual input tray and 95 X 127 mm (3.8” X 5”) for the automatic
input tray, and the maximum size is 216 X 356 mm (8.5” X 14”).
• Set margins at least 6.4 mm (0.25 in.) away from the edges of the media in the software
application.
4.13