Siemens SXG75 - Manual (Page 126)

125 Settings
right page (125) of SXG75, FUG en, A31008-H8900-A1-1-7619 (20.09.2005, 09:13)
© Sie
m
ens AG 20
03, C:
\Siemens\
D
TP
-Sa
tz\P
rod
ukte\
SX
G
75_
Wolf
_5_1
\out-
Te
mplate: X75, V
ersion
2.
2;VAR
La
ngu
age: en; VAR
issue d
ate
: 050
902
Eject card
Eject the RS MultiMediaCard from the
phone safely without losing data
that is still being transmitted to the
card.
C
Press to confirm request.
If card is still busy, confirm the error
message with
C
and try again later.
Memory assistant
Start the memory assistant
(page 21).
Phone identity
The phone identity number (IMEI) is
displayed. This information may be
useful for customer service.
F Switch between tabs to
display additional infor-
mation about the device.
Device check
After the last information page,
a self-test as well as the individual
test are offered. If you select Self test ,
all individual tests are carried out.
Device manager (DM)
Sessions can be initiated in different
ways.
• Manual session: You start the DM
session via this menu option.
• WAP push: Your service provider
initiates a DM session via WAP
push (page 65). You receive an
Over The Air Provisioning (OTAP)
message. The message is dis-
played. Confirm the request to
start the DM session.
The OTAP message can be protect-
ed and you may need a PIN to
open it. Contact your provider for
further information.
• Software update: The phone
checks the software status each
time it is switched on. If an update
is available a request is displayed.
Confirm the requests to start the
software update and to re-boot
your phone.
The phone default settings vary from
service provider to service provider
and can be as follows:
• The settings have already been
implemented by the provider. You
can start immediately.
Software version
To display the software version for your
phone in standby mode:
* # 0 6 #, and select the Configuration tab.
Additional information
If you want to start a session the battery
must be charged at least 50%.