Siemens SXG75 - Manual (Page 13)

Getting started 12
© Siemens AG 20
03, C:
\Siemens\
D
TP
-Sa
tz\P
rod
ukte\
SX
G
75_
Wolf
_5_1
\out-
left page (12) of SXG75, FUG en, A31008-H8900-A1-1-7619 (20.09.2005, 09:12)
Te
mplate: X75, V
ersion
2.
2;VAR
La
ngu
age: en; VAR
issue d
ate
: 050
902
• Press on the tray. The tray for the
card is opened. You can remove
the tray.
• Insert the card on the tray (ensure
that the chamfered corner is in the
correct position 1). Insert the tray
with the card into the phone 2
until it snaps in.
Charging the battery
The battery is not fully charged
when delivered. Plug the charger
cable into the bottom of the phone,
plug the power supply unit into a
mains power socket and charge for
at least two hours.
Only use the plug-in power supply
included in delivery!
As an alternative, the battery can
be charged via the USB port
(Accessories, page 135).
Y
Display during charging.
Charging time
An empty battery is fully charged af-
ter about 2 hours. Charging is only
possible within a temperature range
of +5 °C to 45 °C. If the temperature
rises/falls 5 °C above/below this, the
charge symbol flashes a warning.
The mains voltage specified on the
power supply unit must not be ex-
ceeded.
The charge level of the battery is
only displayed correctly after an un-
interrupted charging/discharging
cycle. You should therfore not remove
the battery unnecessarily and where
possible not end the charging process
prematurely .
Additional information
The power supply unit heats up when used
for long periods. This is normal and not
dangerous.
If the battery is removed for longer than
30 seconds, the clock must be reset.