SMC Networks 100 - Manual (Page 7)

i
C
OMPLIANCES
FCC - Class A
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause interference to
radio communications. It has been tested and found to comply with the limits for a
Class A computing device pursuant to Subpart B of Part 15 of FCC Rules, which are
designed to provide reasonable protection against such interference when operated in a
commercial environment. Operation of this equipment in a residential area is likely to
cause interference, in which case the user, at his own expense, will be required to take
whatever measures may be required to correct the interference. You are cautioned that
changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
You may use 50/125 or 62.5/125 micron multimode fiber optic cable for VF-45, SC, or
ST-type connections.
Warnings 1. Wear an anti-static wrist strap or take other suitable measures to prevent
electrostatic discharge when handling this equipment.
2. When connecting this hub to a power outlet, connect the field ground
lead on the tri-pole power plug to a valid earth ground line to prevent
electrical hazards.
EC Conformance Declaration - Class A
SMC contact for these products in Europe is:
SMC Networks Europe,
Edificio Conata II,
Calle Fructuós Gelabert 6-8, 2
o , 4 a ,
08970 - Sant Joan Despí,
Barcelona, Spain.
This information technology equipment complies with the requirements of the Low
Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC, and carries the CE
Mark accordingly. It conforms to the following specifications:
EMC: EN55024 (1998)/CISPR-22 (1995) Class A
IEC 61000-4-2 (1995) 4 kV CD, 8 kV AD
IEC 61000-4-3 (1995) 3 V/m
IEC 61000-4-4 (1995) 1.0 kV - (power line), 0.5 kV - (signal line)
IEC 61000-4-5 (1995) 2 kV - (line to line), 1 kV - (line to ground)
IEC 61000-4-6 (1995) 3 Vrms
IEC 61000-4-11 (1995) Voltage dip: >95% - 10 ms
30% - 500 ms
60% - 100 ms
Voltage interruption: >95% - 5000 ms