SUPER MICRO Computer SUPERSERVER 6015B-3 - Manual (Page 60)

6-2
S UPER S ERVER 6015B-3/6015B-T User's Manual
Figure 6-1. Chassis: Front and Rear Views
System Reset
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications.
These wires have been bundled together as a ribbon cable to simplify the connec-
tion. Connect the cable from JF1 on the serverboard to the appropriate header on
the Control Panel PCB (printed circuit board). Make sure the red wire plugs into
pin 1 on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons. Details on JF1
can be found in "Chapter 5: Advanced Serverboard Setup."
Control Panel System LEDs
Main Power
Slim Floppy Drive (optional)
SAS/SATA Drive Bays
Power Supply Module PCI Expansion Slots (w/ riser cards)
Mouse/Keyboard
USB Ports
COM1 Port Ethernet Ports VGA Port
Slim DVD-ROM Drive
SAS Port
Note: the external SAS port is included on the 6015B-3 only.