Sony STRDG800 - Manual (Page 37)

37 US
F:\Sony SEM
HA\Revision2_DG800\JC060412_2667346121DG800_US\2667346121\US03CON_STR-DG800-
CEL.fm masterpage: Right
STR-DG800
2-662-258-12 (1)
Getting Star
ted
Error codes
When an error is detected during Auto
Calibration, an error code will appear on the
display cyclically after each measurement
process as follows:
Error code
t blank display t (error code t
blank display)
a)
t PUSH ENTER
a)
Appears when there are more than one error code.
To rectify the error
1 Record down the error code.
2 Press the control button.
3 Press ?/1 to turn off the receiver.
4 Rectify the error.
For details, see “Error code and remedies”
below.
5 Turn on the receiver and perform Auto
Calibration again (page 36).
Error code and remedies
Warning codes
During Auto Calibration, the warning code
provides information on the measurement
result. The warning code will appear on the
display cyclically as follows:
Warning code t blank display t (warning
code t blank display)
b)
t PUSH ENTER
b) Appears when there are more than one warning
code.
You can choose to ignore the warning code as
the Auto Calibration function will
automatically adjust the settings. You can also
change the settings manually.
To change the settings
manually
1 Record down the warning code.
2 Press the control button.
3 Press ?/1 to turn off the receiver.
4 Follow the solution provided in the
“Warning code and solution” below.
5 Turn on the receiver and perform Auto
Calibration again (page 36).
Error and warning codes
Error
code
Explanation Remedies
ERROR
CODE 10 The environment
is too noisy. Make sure the
environment is
quiet during Auto
Calibration.
ERROR
CODE 11 The speakers are
placed too near to
the optimizer
microphone. Place your speakers
further away from
the optimizer
microphone.
ERROR
CODE 20 Front speakers
are not detected
or only one front
speaker is
detected. Check the front
speaker
connection.
ERROR
CODE 21 Only one
surround speaker
is detected. Check the surround
speaker
connection.
ERROR
CODE 22 Only one
surround back
speaker is
detected. Check the surround
back speaker
connection. If you
connect only one
surround back
speaker, connect it
to the SPEAKERS
SURROUND
BACK L terminal.
ERROR
CODE 23 Surround back
speaker is
detected but
surround
speakers are not
connected. Be sure to connect
the surround
speakers.
Error
code
Explanation Remedies
continued
US01COV_STR-DG800-CEL.book Page 37 Tuesday, March 14, 2006 3:53 PM