Sony STRDG800 - Manual (Page 39)

39 US
F:\Sony SEM
HA\Revision2_DG800\JC060412_2667346121DG800_US\2667346121\US03CON_STR-DG800-
CEL.fm masterpage: Right
STR-DG800
2-662-258-12 (1)
Getting Star
ted
8: Adjusting the speaker
levels and balance
(TEST TONE)
You can adjust the speaker levels and balance
while listening to the test tone from your
listening position.
Tip
The receiver employs a test tone with a frequency
centered at 800 Hz.
1
Press AMP, then press MENU.
“1-LEVEL SET” appears on the display.
2
Press the control button or
control button
b to enter the
menu.
3
Press control button V/v
repeatedly to select “TEST
TONE”.
4
Press the control button or
control button
b to enter the
parameter.
5
Press control button V/v
repeatedly to select “TEST
TONE YES”.
The test tone is output from each speaker
in sequence as follows:
Front left
t Center t Front right t
Surround right t Surround back right*
t Surround back left* t Surround left
t Sub woofer
*You will only hear the test tone from the
– surround back left and right speakers when
surround back speaker selection is set to
“DUAL”.
–surround back left speaker when surround
back speaker selection is set to “SINGLE”.
6
Adjust the speaker levels and
balance using the LEVEL menu
so that the level of the test tone
sounds the same from each
speaker.
For details, see “Adjusting the level
(LEVEL menu)” (page 51).
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/–. You can also
use MASTER VOLUME on the receiver.
• The adjusted value are shown on the display
during adjustment.
7
Repeat steps 1 to 5 to select
“TEST TONE NO”.
The test tone turns off.
TUNING –
DISC SKIP
TV VOL
MASTER VOL
TV CH
PRESET
TUNING +
DISPLAY TOOLS
RETURN/
EXIT
AMP
REPLAY ADVANCE
– CATEGORY +
MEMORY
. >
m M
x X
B B
V
v
MENU
H
CLEAR
>10
– /– –
< <
ENTER 0/10
MUTING
2-5
1
MASTER
VOL +/–
US01COV_STR-DG800-CEL.book Page 39 Tuesday, March 14, 2006 3:53 PM