Sega type twin F355 - Manual (Page 27)

20 www.seuservice.com
7. PRINTER (OPTIONAL)
Refer to this section only when the Printer (optional) is attached.
Be sure to turn off power unless otherwise specified before performing work.
Performing work on the energized machine can cause hands or fingers to be
pinched in or in jured due to the machine's sudden move.
Do not touch undesignated places. Failure to observe this may cause a burn
due to the Head's high temperature when printing.
When performing work that uses the cutter, be very careful so as not to cut
hands or fingers.
Be sure to use the exclusively used paper and a Cleaning Pen. Using
unspecified parts can cause malfunctioning and/or a damage to parts.
Be sure to use the new roll paper unwrapped immediately before the use.
Using the roll paper previously unwrapped and left for a while can cause
malfunctioning due to deterioration resulted from humidity.
When setting the paper with the power on, if the paper volume is small, the
Printer might not accept the set roll paper. In that case, follow the "SETTING
THE PAPER WITH THE POWER OFF" procedures to set the paper.
STOP
IMPORTANT!
FIG. 7
ERROR LAMP
When the Printer is malfunctioning, the 2 Error
Lamps attached to the Rear Cabinet back side flash or
light up. The Lamps flash when the paper is
exhausted and light up when the trouble is other than
the running out of paper.
When placing an order, contact where you purchased
the product or the Printer Kit from in stating the
following part number and the description.
The following set (Part Number: 601-10735-01) consists of 4 rolls of exclusively used paper
and a Cleaning Pen.
PART NUMBER: 601-10735-01 DESCRIPTION: PAPER FOR F355 ENG
7 - 1 OPERATION WITH THE PRINTER ATTACHED
The Printer which prints Player's Driving Data and the GAME BOARD do not keep the data to
be printed. When "PRINTING CAN NOT BE DONE" is displayed or the PRINTER is set to
OFF in the Test mode, printing can not be done as the product does not have such system as
printing out the data at a later operation. Therefore, as for the printing, instruct the Player to pay
attention to the following.
Although YES is selected to the "PRINT OUT?" question displayed on the monitor, printing
can not be done if a credit worth coin is not inserted within the time limit. Such credit (coin)
as inserted after the time limit is regarded as a game play credit.
If the Printer malfunctions such as a paper jam occurred during printing, the printing for the
Driving Data can not be done as neither the Printer nor the ROMs on the GAME BOARD
keeps the data.
When "PRINTING CAN NOT BE DONE" is displayed or the PRINTER is set to OFF in the
Test mode, printing can not be done as the product does not have such system as printing out
the data at a later execution.