Sega type twin F355 - Manual (Page 50)

43 www.seuservice.com
12 - 2 VOLUME ADJUSTMENT/REPLACEMENT
The appropriate value of Crutch Volume is under 30H when released and over C0H when
stepped on. Check Volume values in the TEST mode. Since work is performed inside the
energized cabinet, be very careful so as not to touch undesignated places. Touching places not
specified can cause electric shock or short circuit.
Loosen 2 screws which secure the Volume Bracket to adjust the gear mesh.
Tighten the 2 screws.
In the TEST mode, check to ensure that the Volume Values are within the appropriate range and
vary smoothly in consistency with the Pedal operation.
SCREW (2)
M4 X 8,w/flat &
spring washers
VR BRACKET
V.R.220-5484
220-5373
PHOTO 12. 2
Disconnect the connector from the Volume.
Take out 2 screws to remove the Volume together with the VR Bracket from the Crutch Pedal
Mechanism.
Remove the Volume from the VR Bracket to replace.
After replacing the Volume, engage the gears and fix the VR Bracket.
In the TEST mode, check to ensure that the Volume Values are within the appropriate range and
vary smoothly in consistency with the Pedal operation.
REPLACING THE VOLUME
ADJUSTING THE VOLUME
1
2
3
4
5
1
2
3