Sega type twin F355 - Manual (Page 38)

31 www.seuservice.com
Perform the adjustment while another person is securing the Steering Wheel in the centering
position.
The V.R. is on the VR BASE (a white, plastic made part). Loosen the 2 screws which secure
the VR BASE and adjust the angle and appropriateness of gear mesh by moving the VR BASE.
Adjust to an appropriate mesh by securing the Steering Wheel in the direction allowing the car
to advance straight forward and ensuring the "D" CUT FACE of the Volume shaft is oriented as
shown.
Tighten the 2 screws to secure the VR BASE.
Turn on power.
Set the Center Value of the Volume in the TEST mode.
In the TEST mode, check to see if the Volume Value varies smoothly in accordance with the
steering wheel operation.
VR BASE
SCREW (2)
M4 X 12,w/flat & spring washers
FIG. 9. 1 a
"D" CUT FACE
3
4
5
6
7
8
9