Sega type twin F355 - Manual (Page 30)

23 www.seuservice.com
FIG. 7. 2 g
Printer Door
FIG. 7. 2 f
PRINTER TEST
MESSAGE : PRINTER INIT!
ERROR :
WARNING :
STATUS :
COUNTER :
-> INIT
F-FEED
B-FEED
POSITION SET
PRINTER TEST
MESSAGE : NOW PRINT-
ING
ERROR :
WARNING :
STATUS :
COUNTER :
INIT
F-FEED
B-FEED
-> POSITION SET
In case that the paper tip
comes out in excess of the
exit slot, Paper is cut after
Printer feeds Paper one page
long.
Select and execute the INIT in the
PRINTER TEST. The "PRINTER
INIT!!" message flashes next to
"MESSAGE" on the monitor and
then goes off. The Printer's
initialization is finished.
Select and execute the "POSITION
SET." "NOW PRINTING"
message is displayed next to the
"MESSAGE" on the monitor and
then goes off. The Printer starts
automatic feeding of the paper
(AUTO LOADING) and then cuts
the paper automatically. If the
Paper tip position is appropriate,
the automatic feeding's movement
is slight and the paper cutting may
not be done. Before executing the
POSITION SET, the paper
position can be adjusted by
executing F-FEED or B-FEED in
the PRINTER TEST mode.
Exit from the TEST Mode.
Push the ASSY PRINTER up to
the point the PRINTER reaches the
Securing Part in the innermost of
the unit.
Lock the Printer Door to secure.
SETTING THE PAPER WITH THE POWER OFF
Turn off power.
Unlock with the Master Key and remove the
Printer Door.
Draw the ASSY Printer toward you.
Pull up the Head Up Lever.
Take out the roll shaft from the Printer.
Pass the shaft through the core of the new Roll
Paper.
Install the roll shaft in which the paper is inserted
into the unit. Make sure to put the Roll Paper on to
the correct position.
10
11
12
13
14
1
2
3
4
5
6
7