SharkRack 45U - Manual (Page 14)

SharkRack Enclosure Installation Guide
ID-00210-000 REV D, ECO2773 Page 14 of 46
Chapter 3 Configure Accessories into the Cabinet
Configure Optional Accessories
The SharkRack cabinet can be configured using multiple optional accessories. The
configuration depends on your specific application and may vary from cabinet to cabinet. The
following list of processes is organized to help guide you through the typical steps of configuring
optional accessories. Since each configuration is different, some processes may be excluded.
Also, some processes will refer back to previous processes.
• Installing and Removing Doors
• Changing Door Handles
• How to Reverse the Door Swing
• Adjusting the Leveling Feet
• Installing the Retractable Tip Guard
• Installing the Floor Mounting Brackets
• Adjusting or Replacing the Mounting Rails
• Installing Side Mounting Brackets
• How to Remove or Install a Top Panel
• How to Remove or Install Side Panels
• Installing a Grounding Kit
• Using the SharkTRAC™ and SharkSNAP™
• Installing a 19 inch EIA Power Strip
• Cable Management
• Installing a MultiBay Kit
Tools Required for Cabinet setup:
• #2 Phillips Screwdriver
• 1/2” – 9/16” Open End Wrench (Included with leveling foot kit)
• 9/16” Hex Socket and Ratchet with 3” Extension Bar (Optional)
• Straight Blade Screwdriver (Optional for adjusting the leveling feet)