Sony RM-AV2500T - Manual (Page 18)

18 GB
Using Non-Preset Remote Control
Operations
— Learning Function (continued)
To display only the frequently
used keys
You can hide keys you do not use. This
makes operations even easier to
understand, when the components have
many keys.
After Step 2 (page 15), while pressing the
LIGHT button, press the key you want to
hide (flashing). The pressed key changes
to slower flashing and will no longer be
displayed during remote control
operations.
To display it again, perform the same
procedure again.
Note
You can not hide a key which has “learned”
any signal.
To change the function display of
a key
When you programme a signal for a key,
you can select the most suitable function
display among all the displays the key
has, and set it to the key.
1
After Step 2 (page 15), while
pressing the Component Select
button (VCR), press the key you
want to teach repeatedly.
Each time the key is pressed, the
display is changed in order.
2
When the desired display
appears, release the Component
Select button.
3
Then follow Steps 4 to 6 (page
16).
Notes
• You can change the display of a key only
when you programme it using the learning
function. If you want to change the display of
the key that has learned a signal, clear the
signal first (page 19). Then teach the key
again using the above procedure to change its
display.
• If you do not change the display of a key, the
default display is used.
• You cannot change the display of the keys
that are not framed with (the number
keys 0 to 9, +10 and ENTER).