Sony RM-AV2500T - Manual (Page 36)

36 GB
Programming a Frequently Used
Key Operation for SYSTEM
CONTROL Buttons (continued)
3
Press the SYSTEM CONTROL
button you want to teach.
“LEARN” flashes and the display for
the pressed SYSTEM CONTROL key
stays lit.
4
Press and hold down the button
of the remote control until you
hear a beep.
(If you release the button before you
hear a beep, the signal may not be
learned correctly.)
“LEARN” display stops flashing and
stays lit.
If “NG” flashes on the display
Learning did not succeed. Try Steps 3 and 4
again.
5
Press COMMANDER OFF.
Note
You can programme a remote control signal for
a SYSTEM CONTROL button by “learning” for
which the System Control functions have been
programmed. In this case, the System Control
functions are overwritten and cannot be used.
If you clear the “learned” signal from the
button, the System Control function, are
restored, and you can use them again.
To clear the learned remote
control signal
1 While pressing COMMANDER OFF,
press PROGRAM + and w +.
2 While pressing the LIGHT button,
press the SYSTEM CONTROL button
(1 – 9, A, B, or C).
3 Press COMMANDER OFF.
The display for that button flashes.
If you want to programme a new signal
for that button, follow Steps 3 to 5.