Sony RM-AV2500T - Manual (Page 55)

55 GB
Troubleshooting
If you have problems setting up or using the Remote Commander, first check the
batteries (page 6), then check the items below.
Remedy
• Go closer to the component. The maximum operating distance is
approximately 32.8 ft. (10 m).
• Check that you are aiming the Commander directly at the compoent,
and that there are no obstructions between the Commander and the
component.
• Turn on the components first, if necessary.
• Check that the component has infrared remote capability. For example,
if your component did not come with a remote commander, it probably
is not capable of being controlled by a remote commander.
• You have assigned a different component to the Component Select
button. Check the component assigned to that button and the
component code.
• If you do not use the commander for a long time, LCD panel response
may become erratic. In this case, follow the procedure below:
1 While pressing COMMANDER OFF, press MENU and EXIT.
A bullet mark will appear in the bottom left of the LCD panel.
2 Press the next target that appears in the top right of the LCD panel.
3 Press the square that appears in the centre of the LCD panel.
A beep sounds to confirm the setting.
Symptom
You cannot operate the
components.
Continued