Sony SRP-X700P - Manual (Page 43)

– 43 –
• LINE3-4F machine type (1, 3, 5, 7, 9, 11 and 13th byte)
This command is used to set category of the Control S.
• LINE3-4F connection (2, 4, 6, 8, 10, 12 and 14th byte)
This command is used to set the output channel of the CONTROL S signal.
• CONTROL S I/F TYPE (15th byte)
This command is used to set the connection type of the channels 1 to 4 of the CONTROL S OUTPUT terminal.
When you want to set the I/F type to WIRED, set the corresponding bit to 0. When you want to set the I/F type to IR, set the
corresponding bit to 1.
Bits 4 through 7 are fixed all the time.
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
0 1 0 0 CH4 CH3 CH2 CH1
CONNECTION CONNECTION CONNECTION CONNECTION
TYPE TYPE TYPE TYPE
• PJ CONTROL (16th byte)
This command is used to set ON/OFF of the REMOTE POWER ENABLE and selection of the PROJECTOR CONTROL terminal with
the 8-bit data.
When you want to set the REMOTE POWER ENABLE to ON, set bit 1 to 1. When you to set it to OFF, set bit 1 to 0.
Bit 0 (I/F) changes depending on the setup of the “Projector Protocol” described later.
Bits 2 through 7 are fixed all the time.
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
0 1 0 0 0 0 REMOTE I/F
POWER
ENABLE
• Video signal type (17th through 22nd byte)
This command is used to set the type of video signal of the equipment connected to LINE4 A to F.
MACHINE TYPE MACHINE TYPE
NONE 30[H] (‘0’) VTR4(DV) 35[H] (‘5’)
DVD 31[H] (‘1’) MD 36[H] (‘6’)
VTR1(Beta) 32[H] (‘2’) CD 37[H] (‘7’)
VTR2(8mm) 33[H] (‘3’) CD-R 38[H] (‘8’)
VTR3(VHS) 34[H] (‘4’)
CHANNEL TYPE
1 0[H] ‘@’)
2 1[H] ‘A’)
3 2[H] ‘B’)
4 4
4
4
4
3[H] (
(
(
(
‘C’)
SIGNAL DEFINE
VIDEO 30[H] (‘0’)
S VIDEO 31[H] (‘1’)
RGB 32[H] (‘2’)
COMPONENT 33[H] (‘3’)
LAN 34[H] (‘4’)