Sony SRP-X700P - Manual (Page 47)

– 47 –
ROUTING PARAMETER REQUEST : 52[H] 52[H] 4C[H] 31[H]-38[H] (‘RRL1-8’)
52[H] 52[H] 52[H] 31[H]-32[H] (‘RRR1-2’)
This command is used to read setup of the routing to the OUTPUT channels with the 8-bit data from the SRP-X700P.
The commands that correspond to the respective channels are shown below.
• Packet format
52[H] 52[H] 4C[H] 31[H] “parameter” 0D[H]
• Parameter
Specify the scene No. of the scene memory that you want to read, as the parameter.
Method of specifying the scene No. is the same as that of the GROUP FADER command. See page 20.
• Return packet format
When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] (‘A’)) in the
order shown below.
41[H] “parameter” 0D[H]
The parameter is the same as the 19 bytes of the ROUTING command parameter from which the scene No. is exempted.
SCENE INDEX REQUEST : 52[H] 53[H] 43[H] 49[H] (‘RSCI’)
This command is used to read index of the scene memory from the SRP-X700P.
• Packet format
52[H] 53[H] 43[H] 49[H] “parameter” 0D[H]
• Parameter
Specify the scene No. of the scene memory that you want to read, as the parameter.
Method of specifying the scene No. is the same as that of the SCENE STORE command.
• Return packet format
When communication with the SRP-X700P is established with success, the 8-bytes index is returned together with ACK (41[H] (‘A’)) in
the order shown below.
41[H] “index” 0D[H]
CHANNEL Command
LINE OUTPUT 1 52[H] 52[H] 4C[H] 31[H] ‘RRL1’
LINE OUTPUT 2 52[H] 52[H] 4C[H] 32[H] ‘RRL2’
LINE OUTPUT 3 52[H] 52[H] 4C[H] 33[H] ‘RRL3’
LINE OUTPUT 4 52[H] 52[H] 4C[H] 34[H] ‘RRL4’
LINE OUTPUT 5 52[H] 52[H] 4C[H] 35[H] ‘RRL5’
LINE OUTPUT 6 52[H] 52[H] 4C[H] 36[H] ‘RRL6’
LINE OUTPUT 7 52[H] 52[H] 4C[H] 37[H] ‘RRL7’
LINE OUTPUT 8 52[H] 52[H] 4C[H] 38[H] ‘RRL8’
REC OUT 1 52[H] 52[H] 52[H] 31[H] ‘RRR1’
REC OUT 2 52[H] 52[H] 52[H] 32[H] ‘RRR2’