Sony SRP-X700P - Manual (Page 7)

– 7 –
MUTING: 43[H] 4D[H] 55[H] 54[H] (‘CMUT’)
This command is used to mute the specified channel or cancel muting of the specified channel.
• Packet format
43[H] 4D[H] 55[H] 54[H] “parameter” 0D[H]
• Parameter
The parameter consists of the two-byte data in the following order.
• Channel
Same as that of LEVEL UP command.
• Muting
Example: When muting REMOTE1
43[H] 4D[H] 55[H] 54[H]42[H] 41[H] 0D[H] (‘C M U T B A CR’)
PARALLEL OUTPUT OFF: 43[H] 50[H] 4F[H] 46[H] (‘CPOF’)
This command is used to turn off OUTPUT of the REMOTE PARALLEL terminals separately of the SRP-X700P.
• Packet format
43[H] 50[H] 4F[H] 46[H] “parameter” 0D[H]
• Parameter
Specify any single channel that you want to turn off, as the parameter.
Example: When turning off channel 2
43[H] 50[H] 4F[H] 46[H] 32[H] 0D[H] (‘C P O F 2 CR’)
byte Parameter name
1st CHANNEL
2nd MUTING
MUTING
CANCEL MUNTING 40[H] ( ‘@’ )
MUTING 41[H] ( ‘A’ )
CHANNEL
1 31[H] ( ‘1’ )
2 32[H] ( ‘2’ )
3 33[H] ( ‘3’ )
4 34[H] ( ‘4’ )
5 35[H] ( ‘5’ )
6 36[H] ( ‘6’ )
7 37[H] ( ‘7’ )
8 38[H] ( ‘8’ )
9 39[H] ( ‘9’ )
10 3A[H] ( ‘:’ )