Sirius Satellite Radio STAREMATE REPLAY ST2 - Manual (Page 33)

ST2 Starmate Replay User and Installation Guide
33
program in the stored audio, and playback
automatically begins. Repeatedly pressing and
releasing the Rewind Button causes the
Receiver to continue to move backwards in the
stored audio to the start of each previous song
or program until the beginning of the stored
audio is reached. If the beginning of the stored
audio is reached, a beep will be heard (if the
Confirmation Tone option is enabled) and
playback will automatically begin.
Note: Depending upon where in a particular
broadcast the channel was selected, the start of
a song or program may not be available in
memory. If this occurs, the playback will start
from where the audio began to be stored.
Pressing and holding the Rewind button for one
second rewinds playback in 10 second
intervals, which increase to 15 and then 30
second intervals the longer the Rewind button
remains pressed. Playback begins immediately
when the button is released. If the beginning of
the stored audio is reached while rewinding, a
beep will be heard and playback will automatically begin.
Using Instant Replay
To begin using the Instant Replay feature of the
Receiver, press the Pause/Play button. This causes
the Receiver to enter the Instant Replay pause
mode, which mutes the audio from the Receiver. A
“Paused” message will be displayed for two
seconds to confirm that the Receiver has entered
the Instant Replay mode.
001 Ch. Name
Artist Name Artist Name
Song Title Song Title
Paused
-00:00:03
To listen to the audio that was stored, press the
Play/Pause button again and the Receiver will begin
to play back the audio stored in the Instant Replay
memory from the point where you pressed the Play/
Pause button.
As you are listening to the playback of the stored
audio, you may either fast forward or rewind through
the stored audio by pressing the fast-forward or
rewind buttons, without having to press the Play/
Pause button first. Refer to the previous sections