Sirius Satellite Radio STAREMATE REPLAY ST2 User Manual
Page 7
ST2 Starmate Replay User and Installation Guide
7
Installation
Installation of your ST2 Starmate Replay Receiver is
easy:
1. Choose a location in your vehicle where you will
mount the Receiver.
2. Mount the Receiver to the suction cup mount and
attach the suction cup portion of the mount to the
vehicle window, or use the velcro strip to mount the
Receiver.
3. Install the magnetic antenna on the roof of the
vehicle, and route the antenna cable to the Receiver.
4. Connect the power cord for the Receiver to your
vehicle’s cigarette lighter.
5. Subscribe to the SIRIUS service and begin enjoying
the SIRIUS entertainment!
Location
Choose a location in your vehicle where the Receiver
will not block your vision, interfere with the vehicle
controls, or obstruct the air bag. The location should
be suitable for using the suction cup mount, such as
the windshield or other flat, smooth surface, or a
surface suitable for using the velcro mounting.
The location should be easily reachable and provide
good visibility of the Receiver.
Mounting the Receiver
The Receiver may be attached to the vehicle by
using the suction cup mount, or by using the velcro
strips.
If you are using the suction cup mount, attach the
mounting plate to the suction cup mount by using
the provided bolts and hex nuts as shown below. Be
sure the large tab on the mounting plate is facing up.