Sierra Wireless RAVEN 1X 20070914 - Manual (Page 109)

Configuration Commands
Rev 3.0B Feb.08 104
With an AT telnet connection, this command will terminate the
host data mode and return the Raven to an AT mode. Cannot
be accessed in AceManager.
O
Online (Remote): Causes the Raven to go from Command State
to data state. Cannot be configured in AceManager.
OPRG=n
Enables/disables over‐the‐air firmware upgrading of the
Raven. When Sierra Wireless releases a new version of ALEOS,
you can upgrade your remote modems with OPRG enabled.
• n=0 : Disables
• n=1 : Enables
S53=[method][d.d.d.d][/ppppp]
Destination IP address, port, and method. These are used as
defaults for the D (Dial) AT command.
• method= P : UDP
• method=T : TCP
• method=N : Telnet
• d.d.d.d=IP address or domain name
• ppppp=the port address
Examples:
ATS53=T192.168.100.23/12345
ATS53=foo.earlink.com
Telnet to the specified IP at port 12345.
ATS53=192.168.100.23/12345
Query the specified IP at port 12345.
ATS53=/12345
Query port 12345.
Z
Reset the Raven. In AceManager, this command is performed
with the Reset option on the toolbar.
Tip: *DATZ=1 will disable Z.
&W
Writes all changed modem settings. If this command is not
issued, any modified values will revert back to their previous
values at modem reset. Cannot be configured in AceManager.