Sierra Wireless RAVEN 1X 20070914 - Manual (Page 40)

Raven 1x
35 20070914
5. Verify you are in Passthru mode.
AT!STATUS
6. Unlock the module.
AT~NAMLCK=MSL
7. Set the MDN and MSID.
AT~NAMVAL=0,MDN,MSID,0,65535
8. Verify the settings are what you intended to enter.
AT~NAMVAL?0
9. Start the IOTA session.
AT!IOTASTART
Status will be output until IOTA completes with ‘IOTA
Successful’ or ‘ 1012 ERROR’.
10. Reset the module.
AT!RESET
11. Press the reset button on the front of the modem. When
the modem restarts, it should register on the network.
Data Link
After you complete the IOTA session, if you have a Data Link
account, you can set up Data Link in the modem.
Caution: The Raven needs to be activated via IOTA with a standard
“Vision” account before you can enter the Data Link settings. Entering
the Data Link configuration before the Raven is activated will prevent
successful activation.
1. Put modem into passthru mode.
AT\APASSTHRU
2. Verify you are in Passthru mode.
AT!STATUS
3. Set the NAI.
AT$QCMIPNAI=[NAI],1
4. Set the IP address of the primary home agent.
AT$QCMIPPHA=[PHA_IP],1
5. Set the IP address of the secondary home agent.
AT$QCMIPSHA=[SHA_IP],1
6. Set the home agent shared secret key.
AT$QCMIPMHSS=oursecretmnhakey,1
7. Set the AAA shared secret key.
AT$QCMIPMASS=[AAA_Key],1
8. Enable reverse tunneling.
AT$QCMIPRT=1,1