Save the configuration settings, Configure the raven for your equipment, Reset the raven – Sierra Wireless RAVEN 1X 20070914 User Manual
Page 154: Test the raven configuration
Raven 1x
149
20070914
Figure 2-17: AceManager : PassThru
b.
For *PTREFRESH, enter a value of 15.
c.
For *RESETPERIOD, enter a value of 6.
10. Save the configuration settings.
Click the Write button on the tool bar of AceManager and wait
for the message “Write Successful” to appear in the status bar.
11. Configure the Raven for your
equipment.
a.
Make any appropriate changes to the serial port
parameters to match your equipment. These changes
are made under the group Serial.
Caution: Do not under any circumstances change the
*MODEMHISPEED setting from the template configuration, the only
recommended setting to change is the S23 setting.
b.
Follow the directions above to Write the changes to the
modem.
12. Reset the Raven.
a.
Click the Disconnect button.
b.
Press the modem Reset button on the front of the
modem.
c.
Wait until the modem REG indicator is lit.
d.
Disconnect the Raven from your computer.
13. Test the Raven Configuration.
Once the modem has been activated and you’ve built the
command string it is recommended that the Raven modem be
tested previous to field installation.