Samsung Digimax L50 User Manual
Page 129
《129》
FAQ
There must be USB Host Controller and USB root hub under [Universal Serial
Bus controllers].
In addition, double-click on the USB Universal Host Controller and the USB Root
Hub to check if the Device Status states "This device is working properly".
If the Device Status says the device is "not working properly", click the "Driver" tab
and then click [Update Driver] or [Reinstall Driver].
→ When all the conditions mentioned above are met, the computer can support the
USB interface.
[Case 7]
When using the USB hub.
→ There may be a problem in connecting the camera to the PC through the USB
hub if the PC and the hub are not compatible. Wherever possible, connect the
camera to the PC directly.
[Case 8]
Are other USB cables connected to the PC?
→ The camera may malfunction when it is connected to the PC at the same time as
another USB cable. In this case, disconnect the other USB cable, and connect
only one USB cable to the camera.
[Case 9]
When I open the Device Manager (by clicking Start → (Settings) → Control Panel
→ (Performance and Maintenance) → System → (Hardware) → Device
Manager), there are
「Unknown Devices」or 「Other Devices」entries with a
yellow question mark(?) beside them or devices with an exclamation mark(!)
beside them.
→ Right-click on the entry with the question(?) or exclamation (!) mark and select
"Remove". Restart the PC and connect the camera the again. For Windows 98
PC, remove the camera driver also, restart the PC, and then reinstall the camera
driver.
→ Double-click on the entry with the question (?) or exclamation (!) mark, click the
"Driver" tab, and click [Update Driver] or [Reinstall Driver]. If a message appears
asking you to specify the location of the appropriate device driver, specify "USB
Driver" in the CD supplied.
[Case 10]
In some security programs (Norton Anti Virus, V3, etc.), the computer may not
recognize the camera as a removable disk.
→ Stop the security programs and connect the camera to the computer. Refer to the
security program instructions about how to stop the program.