Samsung Digimax L50 - Manual (Page 54)

《54》
■Select the number of pictures in continuous shooting.
- [SINGLE] : Take one picture only
- [CONTINUOUS] : Images will be taken continuously until the
shutter button is released. The shooting
capacity depends on the memory.
- [AEB] : Take three pictures in a series in different
exposures: short exposure (-0.5EV),
standard exposure (0.0EV) and over
exposure (+0.5EV). Use the mode if it is
hard to decide exposure of the object.
※ High resolution and picture quality increases file saving time, which increases stand-by
time.
※ If the [CONTINOUS] sub menu is selected, the flash will be off automatically.
※ If less than 3 pictures are available in the memory, the AEB shooting is not available.
※ It is best to use a tripod for the AEB shooting as the time to save each image file is longer
and the blurring caused by camera shake may occur.
Metering
[ PROGRAM mode ]
■If you cannot obtain suitable exposure conditions, you can change the metering method to
take brighter pictures.
[MULTI] ( ) : Exposure will be calculated based on an
average of the available light in the image
area. However, the calculation will be
biased towards the centre of the image
area. This is suitable for general use.
[SPOT] ( ) : Only the rectangular area in the centre
of the LCD monitor will be metered for
light. This is suitable when the subject in
the centre is exposed correctly, regardless of the back lighting.
●The default metering mode is Multi pattern metering.
●If the subject is not the centre of the focus area, do not use the spot metering as this may
result in an exposure error. In this circumstance, It is better to use exposure compensation.
INFORMATION
Continuous Shooting
[PROGRAM mode]
MULTI
SPOT
METERING
SINGLE
CONTINUOUS
AEB
SHOOTING