Installing the lithium batteries – Sharp VL-NZ10S User Manual

Page 29

Advertising
background image

Preparation

14

Installing the Lithium
Batteries

Installing the Memory Battery

A lithium battery is used to store the memory of
the date and time settings.

1

Slide the cassette compartment door
release and open the cassette compart-
ment door.

Note:
• The cassette holder will extend and open

when the camcorder is connected to a
power source. Be sure to close the cassette
holder before proceeding to the next step
(see page 12).

2

Pull out the lithium battery holder using
a pointed object such as the tip of a
ballpoint pen.

3

Insert the lithium
battery into the
battery holder with the

H side of the battery
facing the m side of
the holder.

4

Push the battery holder back into
position. Press the W mark gently,
then close the cassette compartment
door by pressing the centre until it clicks
into place.

Removing the lithium battery

Perform steps 1 and 2 above,
then lift out the battery from the
battery holder.

CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type CR2025 recom-
mended by the equipment manufacturer.

X KEEP THIS BATTERY AWAY
FROM CHILDREN. IF SWALLOWED,
CONSULT A PHYSICIAN IMMEDIATELY FOR
EMERGENCY TREATMENT.

Z BATTERY MAY EXPLODE IF
MIS-USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS-
SEMBLE OR DISPOSE OF IN FIRE.

• Do not short-circuit, recharge, disassemble, or

heat the lithium battery.

• Should the lithium battery leak, wipe the battery

compartment clean, and then insert a new
battery.

• The lithium battery will last about one year under

normal usage.

Installing the Battery to Remote
Control (Only supplied with VL-
NZ10)

A lithium battery is used to power the remote
control unit.

1

Hold the remote control
facing down, and pull
out the battery holder
while pressing the tab
toward the centre.

2

Insert the lithium battery into the battery
holder with the H side of the battery
facing the m side of the holder.

3

Insert the battery holder back into
position.

Notes on the Use of the Lithium battery

Lithium battery

holder

m mark

H side

m mark

Tab

Advertising
This manual is related to the following products: