Sharp VL-NZ10S - Manual (Page 38)

Basic Operations
Playback
Basic Operations
23
Tape Playback
Available mode:
TAPE-VCR
The LCD monitor screen functions as a handy
playback monitor. Nothing needs to be con-
nected, allowing instant on-screen playback
with the sound through the built-in speaker.
1
Set the Media Selection
switch to TAPE.
2
Hold down the Lock button
and set the Power switch
to VCR.
3
Press j (or k) on the Operation button
to rewind (or fast forward) the tape to the
desired point.
4
Press m to begin playback.
Note:
• If you press the REC START/STOP button in
TAPE-VCR mode, the mark appears
and the camcorder enters Recording
Standby mode. If you do not intend to
record, press l to turn the
mark off,
then press m to begin playback. This will
ensure your previous recording is not
erased (VL-NZ10 only, see page 61).
To stop playback
Press l.
Basic Operations
Playback
Using Earphones
(Commercially available)
Available modes:
TAPE-VCR, TAPE-CAMERA
You can monitor the sound via stereo ear-
phones (commercially available) during
playback or recording. Stereo earphones with a
3.5 mm diameter plug can be used with this
camcorder by using the supplied earphones
connecting cable.
Connect the plug of stereo earphones to the
PHONES jack on the camcorder as shown
below.
Notes:
• Before connecting stereo earphones, turn the
camcorder volume down to the lowest setting.
• The built-in speaker automatically turns off when
stereo earphones are connected to the PHONES
jack.
To turn the power off
Set the Power switch to OFF without pressing
the Lock button.
Note:
• The tape is automatically rewound when
playback reaches the end of the tape.
Lock button
PHONES jack
Operation button
Media Selection switch
Power switch
Earphones connecting
cable (supplied)