Sharp VL-NZ10S - Manual (Page 69)

Advanced Features
54
6
Press l or m to focus on the subject,
then press the SET button.
o: To focus on a more distant subject
p: To focus on a closer subject
7
Press the MENU button to turn off the
menu screen.
• “MF” is displayed.
To return to Auto Focus mode
After performing step 1 to 3 above, press l or
m to select “AUTO”, then press the SET button.
Notes:
• The camcorder may not be able to focus
correctly if the subject is closer than approxi-
mately 1.5 m. Set the zoom control to wide
angle, and try refocusing again.
• If the lens is dirty or fogged, the camcorder may
not be able to focus correctly.
• When “MF” is displayed, you can manually
adjust the focus by pressing l or m, even if the
focus setting screen is not displayed.
Setting the Camcorder to
Full Auto Mode
Available modes:
TAPE-CAMERA, CARD-CAMERA
You can set all manual settings, including
manual focus, white balance, manual exposure
and manual shutter speed, to Full Auto mode in
one operation.
1
In TAPE-CAMERA or CARD-CAMERA
mode, press the MENU button until the
menu screen appears.
2
Press l or m on the operation button
to select T, then press the SET button.
3
Press l or m to select “FULL AUTO”,
then press the SET button.
4
Press l or m to select “EXECUTE”,
then press the SET button.
5
Press the MENU button to turn off the
menu screen.
Note:
• You cannot select “FULL AUTO” when no
manual settings are currently in use.
F O C U S
MF
3 0 min
E F F E C T
MA N U A L
P I C .
S C E N E ME N U
F U L L
A U T O
MA N . F O C U S
W H I T E
E X P O S U R E
S H U T . S P E E D
Q K .
R E T U RN
R E T U RN
B A L .
S E T
E X E C U T E
R E T U RN
A U T O
2 0 min 3 0 min
Manual focus indicator