Sharp VL-NZ10S - Manual (Page 91)

Digital Still Camera
Features
76
Copying an Image from
Card to Tape
Available mode:
CARD-VCR
Use the procedure below to select still images
recorded on a card and insert them in a tape.
1
Insert the recorded card and a Mini DV
cassette into the camcorder.
2
Set the camcorder to TAPE-VCR mode,
then locate where you want to insert an
image on the tape.
3
Set the camcorder to CARD-VCR mode.
4
Press j, k, l or m to select the
desired image, then press the MULTI
button.
• The selected image is displayed in full-
screen.
5
Press the REC START/STOP button.
• The camcorder enters Recording
Standby mode.
6
Press l or m to select “REC”, then
press the SET button to begin copying
the image to the tape.
7
Press the SET button to stop copying.
8
Press l or m to select “CANCEL”, then
press the SET button to cancel Record-
ing Standby mode.
1
4
2
5
3
6
3 0 0 0 - 0 0
2 / 1 P A G E
1
N O RMA L
P L A Y B A C K
3 0 0 0 - 0 0 1
N O RMA L
CARD
0 1 /
3 0 0 0 - 0 0 1
N O RMA L
CARD
0 1 3 3 /
C A N C E L
R E C