Snom 320 - Manual (Page 14)

14 • Installation
[ S N O M 3 2 0 M A N U A L V 1 . 0 0 ]
1
Cleaning
To clean the snom 320, use an anti-static cloth. Please avoid
cleaning liquids as they might damage the surface or the internal
electronics of the phone.
Connecting the phone
First connect one end of the handset cable to the handset and then
to the jack labeled “ ” on the left-hand side of the phone’s bottom.
Next plug the Ethernet (network) cable into the RJ45 connector
labeled “ ”, and plug the other end into the network side to establish a
data link. The second RJ45 connector, labeled “ ”, is for daisy-chaining
further Ethernet devices without the need for a second Ethernet connection
line.
If you are using an external power supply, please insert the plug
of the power supply into the connector labeled “ ” next to the data line
and hook up the casing into the mains.
If you want to use a headset, it can be connected to the audio
jack labeled “ ” on the bottom side of the snom 320.
Clip the cords into the appropriate slots on the footstand or, in the
case of the handset cord, on the bottom shell of the phone (see Fig. 1 in
the chapter Setting up the phone, above).
Keypad
The numeric keypad with the keys 0 to 9, *, and # is used to enter
digits and letters. Depending on the operating mode, different actions can
be performed (see the table below):
• Entry of digits only (e.g., when dialing a phone number)
• Typing in letters and digits by pressing the keys
repeatedly (similar to a cellular phone), etc.