Snom 320 - Manual (Page 88)

88 • Settings
[ S N O M 3 2 0 M A N U A L V 1 . 0 0 ]
6
keys. By turning this setting on, the user will be offered a pickup window
when a mapped destination gets a call and is in the ringing state. The
display will change from the idle state to show the source and destination
of that call and the user can pick up the call by pressing
or the
programmable key currently blinking.
The pickup offer is available as long as the destination is ringing;
it will disappear when is pressed, when the call is connected, when
the call is cancelled by the caller, or when a third party picks up the call.
When the feature is set to “off”, the message will not be shown
on the display; the only indication of the incoming call is the blinking
LED of the programmable key. The pickup, however, will also work in
this case.
Call Waiting Indication: The three available options are “on”,
“visual only”, and “off”. If you select “on”, the second incoming call is
displayed in the lower left corner of the display:
You will also hear a short audible knocking signal behind your
currently ongoing call, indicating that another call is coming in. When
you select “visual only”, the visual indication will be shown on the
display and there will be no audio indication. Set on “off”, Call Waiting
Indication (CWI) is disabled, which means that only one call at a time
can be handled to and from the phone.
Dialtone during Hold: Turning this setting to “on” will produce a
dial tone when a call is being held and enables the user, for example, to
dial a second number. A dial tone will not be played when this setting is
turned to “off”.