Sunrise Global 13-05024 - Manual (Page 17)

16
INSTALLATION INSTRUCTIONS
ELECTRICAL WIRING - INDOOR UNIT
*Only an electrician must do the connection of this unit.
Note: The power of indoor unit is supplied by the
outdoor unit.The outside disconnect switch must
be installed between electrical panel and
condensing unit.
Operation procedures:
1. Open the surface panel.
2. Open the cover and cover plate of electric box.
(Right figure).
3. Remove the receiving window as shown in the
below left figure.
Cover of
electric box
Support
Receiving window
4. Wire pipe should be tightened by the fixed nut and the electric box should be fixed as
shown in the above right figure and the below figure.
Cover of
wiring hole
Fixed nut
Wiring cover
Power connection cord
Connector
Wire pipe
Cover plate of
electric box