Sony MDS-S50 - Manual (Page 20)

20
MDS-S50
Contents
4-7. TEST MODE DISPLAYS
Each time the [LEVEL/DISPLAY/CHAR] button is pressed, the display changes in the following order.
When CPLAY or CREC are started, the display will forcibly be switched to the error rate display as the initial mode.
1. Mode display
Displays “TEMP ADJUST” (C03), “CPLAY1MODE” (C34), etc.
2. Error rate display
Displays the error rate in the following way.
C = AD = )
C = : Indicates the C1 error.
AD = : Indicates ADER.
3. Address display
The address is displayed as follows. (MO: recordable disc, CD: playback only disc)
h =
s = (MO pit and CD)
h = a = (MO groove)
h = : Indicates the header address.
s = : Indicates the SUBQ address.
a = : Indicates the ADIP address.
Note: “–” is displayed when the address cannot be read.
MEANINGS OF OTHER DISPLAYS
Mode display
Error rate display
Address display
Auto gain display
(Not used in servicing)
Detrack check display
(Not used in servicing)
IVR display
(Not used in servicing)
C1 error and jitter display
(Not used in servicing)
AD error and jitter display
(Not used in servicing)
Servo OFF
Tracking servo ON
Recording mode OFF
CLV normal mode
Tracking offset cancel OFF
Groove
Low reflection
CLV A
CLV UNLOCK
When Off
Display
When Lit
Servo ON
Tracking servo OFF
Recording mode ON
CLV low speed mode
ABCD adjustment completed
Tracking offset cancel ON
Tracking auto gain OK
Focus auto gain OK
Pit
High reflection
CLV S
CLV LOCK
N
X
REC
SYNC
L. SYNC
OVER
B/1
A-/REF
TRACK/LP4
DISC/LP2
SHUF/SLEEP
MONO