Sharp Z-336J - Manual (Page 204)

15-50
Chapter 15: Appendix
15
8. If you think the shield-crimping pin or the core probe may be bent, pull them out. If they are
inserted improperly, you may be able to see that they are bent. In this case, realign them. Insert
the tap screw in the hole in the top of the case, and tighten it.
Securing the transceiver's main case and tap
Setting the SQE switch
In general, set the SQE switch as follows:
SQE switch settings
Item Setting
When connected to a node ON
When connected to a repeater OFF