Sharp Z-336J - Manual (Page 59)

7-25
Chapter 7: Computer Link Function
7
5 5 5 5 5 Read network parameters
This is a function used to read the network parameter data for a target node through the network.
It reads the following data.
Network parameter data
- Node number
- Vender name
- Manufacturer model name
- Node name (facility name)
- Address and size of common memory
- Token monitor interval
- Refresh cycle allowable interval
- Refresh cycle measuring interval (actually measured value)
- Minimum allowable distance between frames
- Upper layer status
- FL-net status
- Protocol version
Node number
Vender name
Manufacturer model name
Node name (facility name)
Top address of area 1
Size of area 1
Top address of area 2
Size of area 2
Token monitor time out time
Minimum allowable distance of frames
FL-net status
Protocol version
Upper layer status
Refresh cycle allowable interval RCT set value
Refresh cycle measured value (current value)
Refresh cycle measured value (maximum value)
Refresh cycle measured value (minimum value)
Request message
Response message
Network parameter