Sharp Z-336J - Manual (Page 122)

9-45
Chapter 9: Message transfers
9
9-6 Remote programming and remote monitor functions
The remote programming and remote monitor functions are methods for operating a PC on another node
connected to the FL-net. These are proprietary SHARP functions. These functions can be used only
between PCs that are quipped with SHARP FL-net modules (boards). You can access these functions
using the following support devices.
- Hand held programmer: JW-14PG
- Ladder software: JW-100SP, JW-92SP, and JW-52SP
Although these functions use request TCD (1001) and response TCD (1201) in transmission type mes-
sages, users are not required to make any settings.
[1] Function
- When connecting to a standard network.
You can do the following using a support device connected to node "n."
- Change the program (Writing to the program while the PC is operating is not allowed, for safety
reasons. Change the program only after stopping the PC operation.)
- Monitor remotely
- Change the parameter memory (only possible using the JW-14PG).
- When connected to an expansion network
* The JW20H (JW-20FL5/20FLT) cannot be used as a junction station ("n+2" station or "m "station).
Use a JW30H (JW-20FL5/20FLT) or a JW50H/70H/100H (JW-50FL).
Using a support tool that is connected to node "n," you can do the following.
- Change the program (Writing to the program while the PC is operating is not allowed, for safety
reasons. Change the program only after stopping the PC operation.)
- Monitor remotely
- Change the parameter memory (only possible using the JW-14PG).
n-2 n-1 n n+2 n+2
FL-net
Support
tool
n-2 n-1 n+1 n+2
FL-net
FL-net
m m+1 m+2
Support
tool
*