Sharp Z-336J - Manual (Page 153)

14-4
Chapter 14: Specifications
14
14-3 JW-50FL
[1] General specifications
*1: The JW-50FL cannot be installed on a W70H/100H.
[2] Communication specifications
(1) Communication section specifications
*2: Maximum transfer distance between stations when connecting more than one segment using re-
peaters.
*3: Maximum transfer distance between stations when connecting more than one 10BASE-T segment
using hubs.
Item Specifications
Host PC Install in optional slots on the JW50/70H/100H (max. 5 units) *1
Storage temperature -20 to +70˚ C
Ambient operating
temperature
0 to +55˚ C
Ambient humidity 35 to 90% RH (without condensing)
Vibration resistance
Equivalent to JIS C 0911: Vibration test: width 0.15 mm (10 to 58
Hz), 9.8 m/s
2 (58 to 150 Hz), (2 hours each on the X, Y, Z axes)
Impact resistance Equivalent to JIS C 0912: 98 m/s 2 (3 each on the X, Y, Z axes)
Internal current consumption
(5 VDC)
400 mA
External supply power 12 VDC ±5%, 0.5 A (only needed for 10BASE5 systems)
Ethernet interface
AUI for 10BASE5 (D-sub 15-pin)
10BASE-T (RJ-45 connector)
Programmer interface D-sub 25-pin
Weight Approx. 380 g
Accessory One cable, one instruction manual
Item Specifications
Network compatibility 10BASE5 or 10BASE-T
Transfer speed 10M bps
Physical topology Bus (10BASE5) / Star (10BASE-T)
Transfer media 50 ohm yellow cable (10BASE5), twisted pair cable (10BASE-T)
Transfer system Base band
Maximum transfer distance
10BASE5: 500 m/segment, 2.5 km/network *2
10BASE-T: 100 m/segment, 500 m/network *3
Protocol configuration
Application
Transport
Network
Data link
FA link protocol
UDP
IP
Ethernet V2