Sharp Z-336J - Manual (Page 210)

15-56
Chapter 15: Appendix
15
[2] 10BASE-T (UTP)
(1) How to create a 10BASE-T (UTP) cable
Strip the sheath on a 10BASE-T (UTP) cable
Cut the sheath 40 mm away from the end and
untwist the cables. Lay them out in the same
order as the terminals.
Normally, you use a straight cable.
Terminal arrangement
Cut the signal lines in a 10BASE-T (UTP) cable
Cut the signal lines 14 mm away from the sheath using a nipper.
T568B T568A
Normal
(straight)
Cross cable
8 Brown Brown
7 White/brown White/brown
6 Green Orange
5 White/blue White/blue
4 Blue Blue
3 White/green White/green
2 Orange Green
1 White/orange White/orange
40 mm
14 mm