Sharp Z-336J - Manual (Page 38)

7-4
Chapter 7: Computer Link Function
7
Parameters related to the system configuration are summed up below.
General specifications for configuring an Ethernet system
[2] 10BASE-T system
Connect a hub to a transceiver using a transceiver cable, and the hub can be connected to multiple
nodes. This system is shown below.
When you want to connect a node to a hub, use twisted pair cable (10BASE-T).
Basic connections in a 10BASE-T system
If distance between the nodes is not too great, you can connect a twisted pair cable to a hub directly,
without using a coaxial cable or transceiver.
Item Specifications
Maximum length of a segment 500 m
Maximum number of transceivers that can be
installed within one segment
100
Maximum distance between nodes 2500 m or less (except for the transceiver cables)
Maximum number of nodes in a system 254
Maximum length of transceiver cable (AUI cable) 50 m
Cable length between transceiver and repeater 2 m or less (recommended)
Maximum number of repeaters between two
nodes 2 (However, a link segment is treated as one
repeater, even though it has a repeater at each end.)
: Twisted pair cable
(10BASE-T)